Dewalt Slide Compound Miter Saw Manual

The Dewalt Slide Compound Miter Saw is designed for precision cutting of wood, plastic, and other materials. It features a powerful motor, adjustable bevel settings, and a sliding mechanism for increased cutting capacity. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Devices 7. Operating the Saw 8. Safety Features 9. Care & Maintenance 10. Regulatory Information 11. Troubleshooting

Features at a Glance

Key components: 12-inch blade, adjustable miter and bevel angles, laser guide, and dust collection system.

Feature	Description
12-inch Blade	Provides a wide cutting capacity for various materials.
Adjustable Miter Angles	Allows for precise angle cuts up to 50 degrees.
Bevel Adjustment	Easy adjustment for bevel cuts up to 45 degrees.
Laser Guide	Helps ensure accurate cuts.
Dust Collection	Integrated system to minimize debris.

Installation

Unpack and inspect contents. Place the saw on a stable work surface.

Secure the saw: Use mounting holes to secure to a workbench.
Connect power: Ensure the power cord is properly connected.
Adjust settings: Set miter and bevel angles as needed.

WARNING! Ensure the saw is unplugged during setup to avoid injury.

First-Time Setup

Power on the saw; follow the setup instructions in the manual.

Check blade alignment: Ensure the blade is properly aligned.
Set miter and bevel angles: Adjust to desired settings.
Test run: Perform a test cut on scrap material.

CAUTION! Always wear safety gear during setup and operation.

Specifications

Blade Size: 12 inches.
Motor Power: 15 amps.
Bevel Capacity: 0-45 degrees left and right.
Miter Capacity: 0-50 degrees left and right.
Weight: 56 lbs.
Dust Collection: Yes, with adapter.
Laser Guide: Yes, included.

Controls and Settings

Access settings via the adjustment knobs for miter and bevel angles. The power switch is located on the front panel.

Safety Features: Blade guard, electric brake, and safety switch to prevent accidental starts.

Connecting Devices

Ensure the saw is unplugged before connecting any devices.

Connect to power source: Use a grounded outlet.
Attach dust collection: Connect to a vacuum or dust bag.

Tip: Always check connections before operating the saw.

Operating the Saw

Follow these steps for safe operation:

Adjust miter and bevel settings as needed.
Place material securely against the fence.
Power on the saw and make the cut.
Always keep hands clear of the blade.

WARNING! Never reach over the blade while it is in motion.

Safety Features

The saw includes several safety features to protect the user:

Blade guard to prevent accidental contact.
Electric brake to stop the blade quickly.
Safety switch to prevent unintentional activation.

Care & Maintenance

Regular maintenance is essential for optimal performance:

Keep the blade clean and sharp.
Inspect power cord for damage.
Store in a dry place when not in use.

CAUTION! Always unplug the saw before performing maintenance.

Regulatory Information

This product complies with all applicable safety standards and regulations. For support, visit www.dewalt.com or contact customer service.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Saw does not start	Power connection issue	Check power cord and outlet.
Blade not spinning	Motor issue	Inspect motor and switch for faults.
Inaccurate cuts	Misalignment	Check blade alignment and settings.
Excessive vibration	Loose parts	Tighten all screws and bolts.

Reset: Refer to the manual for reset instructions if available.

Service: For service inquiries, contact Dewalt customer support.