Dewalt Single Bevel Sliding Miter Saw Manual

The Dewalt Single Bevel Sliding Miter Saw is designed for precision cutting and versatility in various woodworking projects. It features a powerful motor, adjustable bevel settings, and a sliding mechanism that allows for wider cuts. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Devices 7. Operating the Saw 8. Safety Features 9. Care & Cleaning 10. Regulatory Information 11. Troubleshooting

Features at a Glance

Key components: Powerful motor, adjustable bevel, sliding arm, laser guide, and dust collection system.

Feature	Description
Powerful Motor	Provides high cutting performance for various materials.
Adjustable Bevel	Allows for precise angle cuts up to 45 degrees.
Sliding Arm	Enables wider crosscuts and increased cutting capacity.
Laser Guide	Helps ensure accurate cuts with a visible line.
Dust Collection	Minimizes mess and keeps the workspace clean.

Installation

Unpack and inspect contents. Place on a stable work surface.

Attach the saw to a workbench or miter saw stand for stability.
Ensure the power cord is properly connected to a grounded outlet.
Adjust the saw's height and angle as needed for your workspace.

WARNING! Ensure all safety guards are in place before operating the saw.

First-Time Setup

Power on the saw; follow the setup instructions in the manual.

Calibrate the laser guide for accurate cutting.
Set the bevel angle according to your project requirements.
Test the saw with scrap wood to ensure proper operation.

CAUTION! Always wear safety goggles and hearing protection while operating the saw.

Specifications

Motor Power: 15 Amp.
Blade Size: 12 inches.
Bevel Capacity: 0-45 degrees left.
Cutting Capacity: 2x8 at 90 degrees.
Weight: 56 lbs.
Dust Collection: 1-1/4 inch vacuum adapter.
Warranty: 3 years limited.

Controls and Settings

Access the bevel adjustment and height settings on the saw's front panel.

Safety Features: Electric brake, blade guard, and trigger lock.

Connecting Devices

Ensure the saw is unplugged before making any adjustments or connections.

Connect a vacuum hose to the dust port for effective dust collection.
Use the laser guide for precise alignment of cuts.

Tip: Always check the power source before connecting the saw.

Operating the Saw

Follow these steps for safe and effective operation:

Adjust the saw to the desired angle and height.
Secure the workpiece against the fence.
Turn on the saw and allow it to reach full speed before cutting.
Use smooth, steady pressure when making cuts.

WARNING! Never reach under the blade while it is in motion.

Safety Features

Includes electric brake, blade guard, and safety switch to prevent accidental starts.

Care & Cleaning

Unplug the saw before cleaning. Use a dry cloth to wipe down surfaces.

CAUTION! Avoid using liquids or solvents on the saw.

Regulatory Information

This product complies with applicable safety standards and regulations. For support, visit www.dewalt.com or contact customer service.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Saw does not start	Power source issue	Check power cord and outlet.
Blade not spinning	Motor malfunction	Contact customer service for repair.
Inaccurate cuts	Misalignment	Recalibrate the saw and check settings.
Excessive vibration	Loose components	Tighten all screws and bolts.

Reset: Refer to the manual for reset instructions if available.

Service: 1-800-433-9258; www.dewalt.com