Dewalt DWS716XPS Miter Saw Manual

The Dewalt DWS716XPS is a powerful 12-inch double bevel sliding compound miter saw designed for precision and durability. It features an integrated XPS cross-cut positioning system for accurate cuts, a powerful 15-amp motor, and a lightweight design for easy portability. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Devices 7. Operating the Miter Saw 8. Accessibility Features 9. Care & Cleaning 10. Regulatory Information 11. Troubleshooting

Features at a Glance

Key components: 12-inch blade, XPS cross-cut positioning system, double bevel capability, adjustable miter angles, and a powerful 15-amp motor.

Feature	Description
XPS Cross-Cut Positioning System	Provides accurate cut line indication without adjustment
Double Bevel Capability	Allows for bevel cuts in both directions
15-Amp Motor	Delivers high power for cutting through tough materials
Lightweight Design	Easy to transport to job sites
Adjustable Miter Angles	Offers precise miter cuts up to 60 degrees

Installation

Unpack and inspect the miter saw. Ensure all parts are included and undamaged.

Place the saw on a stable work surface.
Secure the saw using the provided clamps if necessary.
Connect to a power source: Ensure the voltage matches the saw's requirements.

WARNING! Always use proper safety gear when operating the saw.

First-Time Setup

Power on the saw; follow the setup instructions provided in the manual.

Adjust the miter angle: Use the miter scale to set the desired angle.
Set the bevel angle: Unlock the bevel adjustment and set to the desired angle.
Check blade alignment: Ensure the blade is aligned with the miter slot.

CAUTION! Ensure the saw is unplugged when making adjustments.

Specifications

Blade Size: 12 inches.
Motor: 15-amp motor.
Bevel Capacity: Double bevel up to 48 degrees.
Miter Capacity: 60 degrees to the right and 50 degrees to the left.
Weight: Approximately 50 lbs.
Power Source: 120V AC.
Cutting Capacity: Cross cuts up to 2x8 at 90 degrees.

Controls and Settings

Access the miter and bevel adjustments using the knobs located on the saw.

Safety Features: Blade guard, electric brake, and trigger safety lock.

Connecting Devices

Ensure the saw is unplugged before connecting any accessories.

Attach the dust collection bag if needed.
Connect any additional accessories as per the manual instructions.

Tip: Always check compatibility of accessories with the DWS716XPS model.

Operating the Miter Saw

Follow these steps for safe operation of the miter saw.

Ensure the workpiece is secured before cutting.
Power on the saw and allow the blade to reach full speed.
Make the cut using a smooth, steady motion.
Power off the saw after completing the cut.

WARNING! Keep hands clear of the blade at all times.

Accessibility Features

The DWS716XPS is designed with user-friendly features for ease of use.

Care & Cleaning

Unplug the saw before cleaning. Use a dry cloth to remove dust and debris.

CAUTION! Do not use liquids or solvents to clean the saw.

Regulatory Information

This product complies with all applicable safety standards and regulations. For support, visit www.dewalt.com or contact customer service.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Blade does not spin	Power issue	Check power connection and switch.
Inaccurate cuts	Blade alignment	Adjust blade alignment as per manual.
Excessive vibration	Loose components	Tighten all screws and bolts.
Dust collection ineffective	Clogged bag	Empty dust bag and check for blockages.

Service: For further assistance, contact Dewalt customer service.