Dewalt DW715 Miter Saw Manual

The Dewalt DW715 is a 15-amp, 12-inch compound miter saw designed for precision and durability. It features a powerful motor that delivers a no-load speed of 4,000 RPM, allowing for smooth and accurate cuts. The saw includes a stainless steel miter detent plate with 11 positive stops, an adjustable bevel range of 0 to 48 degrees, and an integrated laser guide for enhanced visibility. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Devices 7. Operating the Miter Saw 8. Maintenance 9. Safety Information 10. Troubleshooting

Features at a Glance

Key components: 15-amp motor, 12-inch blade, adjustable bevel, laser guide, miter detent plate.

Feature	Description
15-amp motor	Powerful motor for efficient cutting
12-inch blade	Large blade for cutting a variety of materials
Laser guide	Helps ensure accurate cuts
Miter detent plate	Stainless steel with 11 positive stops
Adjustable bevel	Range of 0 to 48 degrees for versatility

Installation

Unpack and inspect contents. Place on a stable surface.

Ensure the work area is clean and well-lit.
Secure the miter saw to a workbench or stand.
Connect to a power source with appropriate voltage.
Adjust the saw to the desired angle before use.

WARNING! Always wear safety goggles and ear protection when operating the saw.

First-Time Setup

Power on the saw; follow the setup instructions.

Install the blade: Follow the manufacturer's instructions for blade installation.
Adjust the miter and bevel settings as needed.
Test the laser alignment before making cuts.

CAUTION! Ensure the blade guard is in place before operating.

Specifications

Motor: 15-amp, 120V.
Blade Size: 12 inches.
No-Load Speed: 4,000 RPM.
Miter Capacity: 0 to 50 degrees left and right.
Bevel Capacity: 0 to 48 degrees.
Weight: Approximately 42 lbs.
Laser Guide: Integrated for precision cutting.

Controls and Settings

Access miter and bevel adjustments via the front panel. The laser guide can be activated with a switch located on the side of the saw.

Safety Features: Blade guard, electric brake, and trigger lock for added safety during operation.

Connecting Devices

Ensure the miter saw is connected to a power source before use. Use appropriate extension cords if necessary.

Turn off the saw before connecting to power.
Use a grounded outlet to prevent electrical hazards.

Tip: Always check the power cord for damage before use.

Operating the Miter Saw

Follow these steps for safe operation:

Adjust the miter and bevel settings as needed.
Place the material securely against the fence.
Power on the saw and make the cut.
Always wait for the blade to stop before removing the material.

WARNING! Keep hands away from the blade while operating.

Maintenance

Regular maintenance is essential for optimal performance.

Keep the saw clean and free of debris.
Inspect the blade for wear and replace as necessary.
Check and tighten all screws and bolts periodically.

CAUTION! Always unplug the saw before performing maintenance.

Safety Information

Read all safety instructions before operating the miter saw. Always wear appropriate personal protective equipment.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Saw does not start	Power supply issue	Check power cord and outlet.
Blade not spinning	Motor issue	Inspect motor and switch for faults.
Inaccurate cuts	Misalignment	Check and adjust miter and bevel settings.
Excessive vibration	Worn blade	Replace blade if necessary.

Service: For further assistance, contact Dewalt customer service.