Dewalt Double Bevel Sliding Miter Saw Manual

The Dewalt Double Bevel Sliding Miter Saw is designed for precision cutting and versatility. It features a powerful motor, dual bevel capabilities, and a large cutting capacity, making it ideal for both professional and DIY projects. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Devices 7. Operating the Saw 8. Safety Features 9. Care & Cleaning 10. Regulatory Information 11. Troubleshooting

Features at a Glance

Key components: Dual bevel capability, sliding feature for wider cuts, laser guide for precision, and adjustable miter settings.

Feature	Description
Dual Bevel	Allows for bevel cuts in both directions without repositioning the workpiece.
Sliding Mechanism	Enables wider crosscuts and increased cutting capacity.
Laser Guide	Helps ensure accurate cuts by projecting a line on the workpiece.
Adjustable Miter Settings	Provides precise angle adjustments for various cutting needs.
Dust Collection	Integrated system to minimize dust and debris during operation.

Installation

Unpack and inspect contents. Place the saw on a stable work surface.

Secure the saw to a workbench or stand for stability.
Connect to a power source: Ensure the voltage matches the saw's requirements.
Check all safety features before operation.

WARNING! Ensure the saw is properly secured to avoid accidents during use.

First-Time Setup

Power on the saw and familiarize yourself with its features.

Adjust the miter and bevel settings as needed.
Test the laser guide alignment before making cuts.
Ensure all safety guards are in place.

CAUTION! Always wear appropriate safety gear when operating the saw.

Specifications

Model: Dewalt DWS780.
Motor: 15 Amp, 3,800 RPM.
Blade Size: 12 inches.
Cutting Capacity: 2x14 at 90 degrees, 2x10 at 45 degrees.
Bevel Capacity: 0-49 degrees left and right.
Weight: Approximately 56 lbs.
Power Source: 120V AC.

Controls and Settings

Access the miter and bevel controls located on the front of the saw. The laser guide can be activated via a switch on the side panel.

Safety Features: Blade guard, electric brake, and anti-kickback system.

Connecting Devices

Ensure the saw is unplugged before making any adjustments or changes.

Connect to a power outlet using the provided cord.
Use appropriate extension cords if necessary, ensuring they are rated for the saw's power requirements.

Tip: Always check the power source before connecting the saw.

Operating the Saw

Follow these steps for safe operation:

Adjust the miter and bevel settings as required.
Position the workpiece securely against the fence.
Engage the safety switch and power on the saw.
Make the cut, ensuring hands are clear of the blade.

WARNING! Never reach over the blade while it is in motion.

Safety Features

The saw is equipped with several safety features to protect the user:

Blade guard to prevent accidental contact.
Electric brake to stop the blade quickly.
Anti-kickback mechanism to prevent the workpiece from moving unexpectedly.

Care & Cleaning

Unplug the saw before cleaning. Use a dry cloth to remove dust and debris.

CAUTION! Avoid using liquids or aerosols near the saw.

Regulatory Information

This saw complies with all applicable safety standards. For support, visit www.dewalt.com or contact customer service.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Motor does not start	Power source issue	Check power connection and outlet.
Blade not spinning	Safety switch engaged	Ensure safety switch is released.
Inaccurate cuts	Misalignment	Check and adjust miter and bevel settings.
Excessive vibration	Loose components	Tighten all screws and bolts.

Reset: Refer to the manual for reset procedures if applicable.

Service: For service inquiries, contact Dewalt customer support.