Dewalt Cordless Sliding Miter Saw Manual

The Dewalt Cordless Sliding Miter Saw is designed for precision cutting and versatility in various woodworking projects. It features a powerful motor, adjustable bevel settings, and a sliding mechanism for wider cuts. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Devices 7. Operating the Saw 8. Safety Features 9. Care & Cleaning 10. Regulatory Information 11. Troubleshooting

Features at a Glance

Key components: Cordless design, adjustable miter angles, laser guide, dust collection system, and ergonomic handle.

Feature	Description
Cordless Design	Allows for mobility and ease of use without power cords.
Adjustable Miter Angles	Enables precise angle cuts up to 45 degrees.
Laser Guide	Helps in aligning cuts accurately.
Dust Collection System	Minimizes mess and keeps workspace clean.
Ergonomic Handle	Provides comfort during extended use.

Installation

Unpack and inspect contents. Ensure all parts are included.

Place the saw on a stable surface.
Attach the dust collection bag if required.
Ensure the battery is charged and properly installed.
Check all safety features before operation.

WARNING! Always wear safety gear when operating the saw.

First-Time Setup

Power on the saw; follow the setup instructions in the manual.

Adjust the miter angle to the desired setting.
Check the blade alignment and adjust if necessary.
Test the laser guide for accuracy.
Perform a test cut on scrap material.

CAUTION! Ensure the area is clear of obstacles before cutting.

Specifications

Blade Size: 12 inches.
Voltage: 20V MAX.
Cutting Capacity: 2x8 at 90 degrees, 2x6 at 45 degrees.
Weight: 56 lbs.
Battery Type: Lithium-Ion.
Speed: 3800 RPM.
Warranty: 3 years limited.

Controls and Settings

Access settings via the control panel. Key controls include power switch, miter angle adjustment, and bevel adjustment.

Safety Features: Blade guard, electric brake, and safety switch.

Connecting Devices

Ensure all connections are secure before operating the saw.

Check battery connection.
Ensure the dust collection system is properly attached.

Tip: Always disconnect the battery when not in use.

Operating the Saw

Follow these steps for safe operation:

Ensure the workpiece is secured.
Power on the saw and allow it to reach full speed.
Make the cut, keeping hands clear of the blade.
Turn off the saw after completing the cut.

WARNING! Never reach over the blade while it is in motion.

Safety Features

Includes blade guard, electric brake, and safety switch to prevent accidental starts.

Care & Cleaning

Unplug and remove the battery before cleaning. Use a dry cloth to wipe down the saw.

CAUTION! Do not use liquids or solvents for cleaning.

Regulatory Information

This product complies with FCC regulations and safety standards. For support, visit www.dewalt.com or contact customer service.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Saw does not start	Battery issue	Check battery charge and connection.
Blade not spinning	Safety switch engaged	Ensure safety switch is released.
Inaccurate cuts	Blade misalignment	Adjust blade alignment as per manual.
Excessive vibration	Loose parts	Tighten all screws and bolts.
Dust collection ineffective	Clogged bag	Empty dust bag and check for blockages.

Reset: Refer to the manual for reset instructions if available.

Service: For service inquiries, contact Dewalt customer support.